Drill Press Fence?
#13
A couple DP table construction tips  

(1) Offset the table so that your chuck centerline is NOT dead center in your table's backer insert.  This way, all you need to do is rotate the insert to get a fresh surface behind your bit, and you can even flip it over for more unused surfaces.  

(2) Build a shelf that goes between your new table and your DP's original metal table.  This provides a lifted offset so that your DP's elevation crank arm is not obstructed by your new bigger table surface plus it allows for a storage area for your often used tools or bits.

(3) A vacuum attachment is very convenient.
[Image: IMG_2596_001.JPG]
[Image: IMG_2597_001.JPG]
Reply
#14
Thanks all!  Very helpful and exactly what I needed!
MAKE: Void your warranty, violate a user agreement, fry a circuit, blow a fuse, poke an eye out...  www.makezine.com

No Good Deed Goes Unpunished

Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.