Next in the shop?
#13
  Re: Next in the shop? by bandit571 (Well, right now, I a...)
Ok...about that Miter saw....decided to repair the OEM handle..for now...was last seen hiding in a couple of clamps.. Winkgrin  
   
got it out of the clamps, today.   got out the Dremel with a couple sanding drums....and proceeded to blend things together, and strip the old finish off..then install it back onto the saw plate it came from...even clocked the cleaned up bolts.. Cool 
   
Looks better than it did, at any rate Rolleyes  
   
Then gave it a coat of stain... Cool  
   
Maybe tomorrow, I can add a coat of Varnish?   Was then able to put the "pattern" handle back onto it's own saw plate 
   
The 3 bolt handle is for a Stanley No. 358 Mitre Box....the longer one? 
   
Goes here...Langdon No.75 Mitre Box.    I suppose I could use the rehabbed Goodell Pratt Company saw in the Langdon....as for the blank I was going to shape? Uhoh  
   
may save, for the next broken down handle that shows up?
Show me a picture, I'll build a project from that
Reply
#14
  Re: Next in the shop? by bandit571 (Well, right now, I a...)
Will be starting a new thread...something about a stack of boards.. Rolleyes
   
And a "Plan" .... Uhoh 
   
Which means I need to "clear the bench for action" Winkgrin 

Look for a Build along about a Computer Desk....coming soon Cool
Show me a picture, I'll build a project from that
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)