Lathe tool holder plans?
#14
(04-30-2020, 12:38 PM)crokett™ Wrote: I made one using PVC that hangs on the wall behind my lathe. It has a plywood back, and bottom and triangle gussets on the ends.  I cut the PVC at an angle on the top and bottom ends so I could run screws through the PVC into the back of the rack.  Over time I've added bits to the front edge on the bottom to hang various accessories.

My lathe sits in the middle of the room (sort of) so I can work all around it.  But I could look at modifying your idea to a mobile one
Reply
#15
I hang all my tools from a 2X2 over the lathe. Readily accessible, easy to do. I screwed an eyelet into the end of the tool handle and corresponding hook in the 2X2.

GM
The only tool I have is a lathe.  Everything else is an accessory.
Reply
#16
I did think of getting one or two of these for different things but only when I get the funds.

https://www.harborfreight.com/three-shel...-6650.html


https://www.harborfreight.com/30-inch-x-...97542.html
As of this time I am not teaching vets to turn. Also please do not send any items to me without prior notification.  Thank You Everyone.

It is always the right time, to do the right thing.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.