Staked shop stool
#13
So here’s the fixture. I planed chamfers on the edge of a couple of pieces of 1 x something (don’t know...leftover offcuts) and screwed them to a piece of plywood, which is then clamped into my wagon vise.

The holdfast does pretty well...I used a thicker piece of wood, thinking that the notch would help with round stock, but it does quite well as you see here...it still holds pressure while I rotate the stock.

Thanks for looking!


Attached Files Image(s)
   
Dave Arbuckle was kind enough to create a Sketchup model of my WorkMate benchtop: http://www.arbolloco.com/sketchup/MauleSkinnerBenchtop.skp
Reply
#14
Here’s the final status for the day...legs fitted & cut to length. I still need to chamfer the seat bottom and make stretchers. I’ll probably scoop out the seat as well.

The front of the stool is about 8 1/4 inches below the bench top and the back is about 3/4 inch higher. Seems like a pretty good height & angle so far, and a lot more stable than the first attempt.
Smile

Thanks for looking.


Attached Files Image(s)
   
Dave Arbuckle was kind enough to create a Sketchup model of my WorkMate benchtop: http://www.arbolloco.com/sketchup/MauleSkinnerBenchtop.skp
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.