Router or Rasp?
#12
(10-03-2020, 01:49 PM)handi Wrote: This was exactly what I was thinking.

But shouldn't I use a 3/4" Radius Round Over Bowl Bit? (The one in that link has a 1/2" radius).

Now, I see a lot of 3/4" round-over bits on the internet, but the angles are not mentioned. (That 10° angle is important).

Outside of that, I do have block planes and just need to pick up sanding blocks.

Thanks.

Darren Harris
Staten Island, New York.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.