02-03-2016, 08:12 PM
Anyone have this jig opinion please
Leigh rtj 400 users review
|
02-03-2016, 08:12 PM
Anyone have this jig opinion please
02-04-2016, 05:53 AM
Wife bought me one for a present-i have never usd it though! Where n PA are you located, in case you're near enough to take a look.
Waiting to grow up beyond being just a member
www.metaltech-pm.com
02-04-2016, 08:31 AM
Chester Springs
02-04-2016, 07:46 PM
I bought this a while back to build a bedroom set with lots of drawers. As with these jigs the setup takes some time, but once done it was like corn through a goose. I have used a jig that mounted the piece in the jig and was never satisfied with that one. Being table mounted this is so much more safe and I absolutely love it. Very easy to manage dust collection and get consistent results. I also used it for a bit more complex setup with lipped half dovetails and worked perfectly. I highly recommend this:
02-04-2016, 07:49 PM
Thanks Rich
02-04-2016, 07:54 PM
mbw said: Well, that's about 170 miles away! If you're in DuBois, you're welcome to drop by. The unit appears well made and straight forward to use. But, as I said, I've never used it-cut my dovetails by hand and have for going on 15 years.
Waiting to grow up beyond being just a member
www.metaltech-pm.com
02-04-2016, 08:07 PM
|
|
Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.