+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: stupid mistake... Need suggestions (/showthread.php?tid=7251711)
Re: stupid mistake... Need suggestions - dow - 04-05-2016
theeviltwinn said:
OMG. I know that guy.
My brother-in-law's cousin is married to that guy's proctologist.
Twinn
Yep, that's him. What a pain in the butt.
Re: stupid mistake... Need suggestions - geek2me - 04-06-2016
dow said:
Yep, it's going the right way.
In rereading the thread, it sounds like the issue might be that the spindle is not really locked, so here is another idea.
This lathe has an outboard spindle,doesn't it? Get two nuts to fit that spindle and thread them onto the spindle with a nylon washer between them!!;-) Tighten them against each other to make a jam nut. Use the wood in the chuck to brace the chuck against the bed. Put a socket over the jammed nuts on the outboard spindle, put a breaker bar on the socket, and a pipe "cheater bar" on the breaker bar. Rotate CCW. This will allow you to apply a lot of force to the chuck/spindle, but be careful - you could twist the spindle if you apply too much force. Another option if you have impact tools is to use the impact on the nuts.
This will work around the spindle lock, you are effectively holding both sides of the attachment point. You can pretty readily apply 1000 ft-lbs or more of torque this way, and if that doesn't break it loose, something must be really wrong, like the spindle is pressure welded or something like that.
Re: stupid mistake... Need suggestions - Rich W - 04-18-2016
Any luck removing the chuck??
Re: stupid mistake... Need suggestions - Bob Atchison - 04-19-2016
Need a chuck status update, please.
Re: stupid mistake... Need suggestions - geek2me - 04-19-2016
Bob Atchison said:
Need a chuck status update, please.
Yes, what the chuck?
Re: stupid mistake... Need suggestions - geek2me - 05-09-2016
Bob Atchison said:
Need a chuck status update, please.
Still no update....
My guess is he finally figured out he was tightening it rather than loosening it.
Re: stupid mistake... Need suggestions - Bob Atchison - 05-09-2016
I think you are correct.
How do you tell a guy he is chucking up?
Re: stupid mistake... Need suggestions - MidwestMan - 05-09-2016
I wonder what the chuck happened.
Re: stupid mistake... Need suggestions - Ruler2112 - 05-14-2016
Chuck off?
RE: stupid mistake... Need suggestions - geek2me - 08-23-2016
(04-05-2016, 03:18 PM)dow Wrote: Yep, it's going the right way.
Did you ever resolve this? What was the issue and solution?