Pin and Tail spacing method - Printable Version +- Woodnet Forums (https://www.forums.woodnet.net) +-- Thread: Pin and Tail spacing method (/showthread.php?tid=7038836) |
Pin and Tail spacing method - Sawdustd - 06-21-2015 Megan Fitzgerald's video breaks the code/simplifies pin and tail spacing IF you start with 1/pin - tail - pin. Question: Is there a similar method if you start with 1/2 tail, pin, tail? I'm starting on a blanket chest build and prefer this sequence. Re: Pin and Tail spacing method - Martin S. - 06-05-2016 It works exactly the same way, I start with half a tail, and it works fine. Re: Pin and Tail spacing method - Carl Grover - 06-05-2016 link to the video? carl Re: Pin and Tail spacing method - Mike Brady - 06-05-2016 Is this the method where you step off the tails with dividers? Martin is correct. You just lay out the half pins where you want them and then get your dividers set for the number and spacing of full pins and tails. I haven't seen Megan's method, but I use the one that Rob Cosman teaches and it gives perfect layout results. Videos are almost essential for learning it however. Edit: There is another thread on this topic running right now. Check it out. Re: Pin and Tail spacing method - Mike Brady - 06-05-2016 Here |