+- Woodnet Forums (https://www.forums.woodnet.net)
+-- Thread: Fixing a cupped iron?? (/showthread.php?tid=7165286)
Pages:
1
2
Fixing a cupped iron?? - DaveParkis - 12-10-2015
I have been extremely lucky over the last few years when buying planes, but it appears that my luck has run out. Several planes I've bought recently have irons that have cupped. Is there a relatively easy way to fix this? Would hammering it on an anvil work? Thanks!!
Re: Fixing a cupped iron?? - Boatman53 - 12-10-2015
How badly cupped are they Dave? I've never seen a cupped plane blade, but then again I just have my set of users and I'm not dealing. The chip breaker and cap iron don't flatten it?
Jim
Re: Fixing a cupped iron?? - barryvabeach - 12-11-2015
Dave, I have hammered a few pieces of steel - what has worked best for me is to support the two ends with the convex side facing up, and tap down on the middle. I did try that with an old laminated iron that was badly cupped, but it didn't work out so well because the lamination started to separate. Another option is to put in in a vise with some shims and try to gradually bend it back into shape.
Re: Fixing a cupped iron?? - Scoony - 12-11-2015
I made a single iron smoother and could not get the blade to adjust for proper shavings. Finally realized that the blade was bowed, enought that the wedge was not flattening it.
I am also interested in how to get that blade flat without ruining it. I have not tried to bend it yet as I have been busy with other stuff. But I am sure that is the reason I am unable to tune that plane.
Re: Fixing a cupped iron?? - Acorn - 12-11-2015
Depending on the degree of difficulty in flattening your iron, you may want to consider just replacing them on flea-bay or upgrading to a Ron Hock or Lee Valley new blade. Not exactly "sporting" if you are a serious rehabber, but may be a lot less of a hassle.
Re: Fixing a cupped iron?? - Timberwolf - 12-11-2015
Quote:
Would hammering it on an anvil work? Thanks!!
Not on a flat surface...It "may" work if you do as Barry suggested....
Re: Fixing a cupped iron?? - Boatman53 - 12-11-2015
I also remember plastic tubs of plane blades in a post by Gregory of Sherwood Forest. But of course you already know how to contact him, this comment is for others that might be following along.
Jim
Re: Fixing a cupped iron?? - AHill - 12-11-2015
Unless you have a lot of experience using a hammer to flatten steel, you may do more damage than good. It often works with cupped saw blades, but saw blades are much softer than plane blades. Every time you hit a plane blade, you're hardening the surface, and increasing the chance that it might chip in use if the hammering is near the edge.
I'm with the camp that says either try to find a replacement blade on eBay or order a replacement blade from any one of several sources. I like Hock. Lee Valley and Lie-Nielsen also sell replacement blades.
Re: Fixing a cupped iron?? - Steve N - 12-11-2015
For the time involved to actually get it flat, well at least for my money, replacement sounds like a good plan
Re: Fixing a cupped iron?? - Wilbur Pan - 12-11-2015
If the cupping makes the back of the blade slightly concave, that may not be a bad thing. Having some concavity on the back side makes flattening the blade a lot easier, since all you have to do is get the perimeter of the blade flat instead of the whole thing.