+- Woodnet Forums (https://www.forums.woodnet.net)
+-- Thread: Jointer Fence Warped and Twisted (/showthread.php?tid=7328932)
Pages:
1
2
Jointer Fence Warped and Twisted - Tapper - 03-22-2017
I'm changing out the cutterhead on my ShopFox 8" jointer and while removing the fence noticed it was twisted and has a bow in the middle. Machine is ~10 years old and until now I've compensated. Looking online it looks like folks sit them on 2x4's and then stand in the middle to hopefully straighten it. Some also clamp one end to a bench and clamp a 2x4 to the other end and attempt to "twist" the twist out of it.
Having it re-ground is always an option, but looks like the most expensive. What say you?
Thanks,
Doug
RE: Jointer Fence Warped and Twisted - museumguy - 03-22-2017
I'd compare the cost of a new fence versus having it ground flat and straight. If a new fence comes in twisted, you can send it back under warranty. It's worth a shot either way.
RE: Jointer Fence Warped and Twisted - JGrout - 03-22-2017
RE: Jointer Fence Warped and Twisted - Downwindtracker2 - 03-23-2017
Some casting are "semi steel" and are bendable, I' ve done it. Others are such poor quality if you look at them badly, they break. I've done that ,too.
RE: Jointer Fence Warped and Twisted - Z28Doug - 03-23-2017
Maybe add a wood face to it, flatten it, then a plastic laminate smooth face for less friction?
RE: Jointer Fence Warped and Twisted - Strokes77 - 03-23-2017
glue some sandpaper down on a granite plate and get to work lapping?
RE: Jointer Fence Warped and Twisted - castguy2003 - 03-23-2017
Send it out, have it surface ground.
RE: Jointer Fence Warped and Twisted - Tapper - 03-23-2017
Swung by a machine shop this morning and got a ballpark estimate from the owner/machinist after describing the job to him, of $150 - $250. Said he could dial it in a little closer if I brought it by for him to see. More than I'm willing to spend. May take a shot at trying to sand it out myself on a rigid flat surface with stick-on sandpaper.
Doug
RE: Jointer Fence Warped and Twisted - barryvabeach - 03-23-2017
Doug, depending on how much of a bow, that could be an awful lot of sanding. I had a similar problem with a Powermatic 50 fence, and I did the stand on it with shims on the ends, and made it better.
RE: Jointer Fence Warped and Twisted - Joe Connors - 03-24-2017
I had the same problem and I had it ground flat. It was 15-20 years ago. I believe the cost was $35.00 I would try another shop and bring the fence with you.