+- Woodnet Forums (https://www.forums.woodnet.net)
+-- Thread: Need help identifying bandsaw parts Delta14 (/showthread.php?tid=7329553)
Need help identifying bandsaw parts Delta14 - weelis - 04-17-2017
I have taken off the lower blad guide mechanism to soak it and clean it up. I am left with 4 1/2 by3/4 thin metal pieces each with a small slot i9n the top which houses a small coil spring. I don't kn ow their function or where they go in reassembling the guide. I assume they are essential. Anyone have any ideas??? Thanks.
RE: Need help identifying bandsaw parts Delta14 - ez-duzit - 04-17-2017
Google Delta 14 manual
RE: Need help identifying bandsaw parts Delta14 - bobburk - 04-17-2017
Your best bet would be going to vintagemachinery.org site. Click on the machinery info. tab. From there select Publication Reprints. This will take to an area where you can scroll down til you find Delta Manu. This will take you to another page where you can select what type of machine your looking for from the drop down. I the info. can be printed. Hope this helps.
Bob
RE: Need help identifying bandsaw parts Delta14 - weelis - 04-17-2017
Thanks. Will try that . Have ma nual that came with maching but doesn't give me much info or help.
RE: Need help identifying bandsaw parts Delta14 - weelis - 04-17-2017
I was hoping someone would read this and know exactly what I am talking and be able to hhelp me from their own experience,
RE: Need help identifying bandsaw parts Delta14 - JGrout - 04-17-2017
they go inside the adjustable fore and aft guide and the back bearing guide to keep the guides in place without the need for lock screws like the top guides use.
It has been awhile since I had to take them that far apart but IIRC other than getting them set and holding them in place while installing them it is fairly straightforward. The springs in the holes the plates over those and the unit into the holder
Joe
RE: Need help identifying bandsaw parts Delta14 - Greg Jones - 04-18-2017
Here is what they look like, left side when viewed from the rear of the saw.
RE: Need help identifying bandsaw parts Delta14 - weelis - 04-18-2017
Thanx Greg. Exactly what I was looking for. I owe you.