05-29-2017, 12:54 PM
So, nothing's easy.
On my frost free faucet, the pex line was 1/2". So I just needed to get a 1/2" elbow to a female threaded.
But, of course, because that elbow is soldered onto the old faucet, I can't pull it through the hole in the wall.
What's the easy way to cut that elbow off? I assume I can't use one of the gizmos that spin around the pipe, cause there's no room. And, where it is under my sink, there's pretty much no way I can use a hack saw or something to cut it.
Thoughts?
On my slop sink faucet (original pic), the replacements I've seen need the pipes coming down from the top. Without learning how to solder, what's the best way for me to modify one for the tubes coming up from the bottom? a bunch of Sharkbites?
On my frost free faucet, the pex line was 1/2". So I just needed to get a 1/2" elbow to a female threaded.
But, of course, because that elbow is soldered onto the old faucet, I can't pull it through the hole in the wall.
What's the easy way to cut that elbow off? I assume I can't use one of the gizmos that spin around the pipe, cause there's no room. And, where it is under my sink, there's pretty much no way I can use a hack saw or something to cut it.
Thoughts?
On my slop sink faucet (original pic), the replacements I've seen need the pipes coming down from the top. Without learning how to solder, what's the best way for me to modify one for the tubes coming up from the bottom? a bunch of Sharkbites?