question on track saws
#14
(02-13-2018, 01:29 PM)ez-duzit Wrote: "Figure i have them, and i am not in that big a hurry"


I could unplug my table saw each time I need to adjust the blade height or move the fence, but I don't.

Come on you guys! At least TRY it without clamps. Unless you don't have a Festool.

Nah, I'd rather be safe than sorry. I own a track saw and table where the track is hinged to hold down the work, it acts like a clamp. When not using the table, I clamp the track. It only takes 15 seconds to clamp the track, it would take a lot longer to correct a problem do to a slip. Also the clamps act like little legs to set the system down. I unplug my circ saw when making adjustments too, but stop short of belt and suspenders.
Train to be miserable...
that way when the real misery starts you won't notice.
Reply
#15
Good management of dust hose and power cord is key to keeping the guide from moving during the cut. I clamp my Makita.
Reply
#16
I have the Shop Foz which is a knock off of a knock off. I never clamp and it doesn't slip. These saws are designed primarily for sheet goods, rough sawn and all bets are off.
RD
------------------------------------------------------------------
"Boy could I have used those pocket screws!" ---Duncan Phyfe
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.