#12
Anyone know where I can get parts for an MM 16 bandsaw? Specifcally I need the locking rings for the upper blade guides

Thanks
Rick

Reply

#13
I would start here

Joe
Let us not seek the Republican Answer , or the Democratic answer. Let us not seek to fix the blame for the past. Let us accept our own responsibility for the future  John F. Kennedy 



Reply

#14
page 7 shows similar pins I have in my MM16

If yours are the same and you cannot determine the size I can pull one apart and give you the information.

Joe
Let us not seek the Republican Answer , or the Democratic answer. Let us not seek to fix the blame for the past. Let us accept our own responsibility for the future  John F. Kennedy 



Reply

#15
what year is your MM16? IIRC, there are a few different versions of guides... I would assume they have different locking rings.
You are frequently puzzled by things you tell us you fully understand. - Bob10 to EH 9/22/16

Too much has been made out of my mostly idle comments  - Cletus 12/9/15

You sound like one of those survivalist, hoarder, tin foil hat, militia, clinger, wackjobs.  - Fear Monger 1/30/13
Reply

#16
Dan - not sure of the exact year - I bought it used. I believe it is a mid 90's? it has the 4.8 kw motor.
Rick

Reply

#17
Well I got in touch with Parts Pronto (linked above) - after some stumbling we came up with the part number based on their parts schematic - $75 - HOLY COW!! They only thing I can figure is they areactually selling the entire bearing assembly and not just the locking ring. I'm going to take a different approach and see if I can findf something with an M22 x 1/5 internal thread that I can turn into a locking ring.
Rick

Reply

#18
When I looked in my manual (just a glance) yesterday, it did appear that was listed as an assembly. Your approach makes more sense, or ask a machine shop to help.
I started with absolutely nothing. Now, thanks to years of hard work, careful planning, and perseverance, I find I still have most of it left.
Reply
#19
Joe - I don't think we are on the same page - not sure what the pins you linked to are for? I'm talking about the knured internally threaded ring that locks the upper bearings in place. They appear to be a m22 x 1.5 pitch.
Rick

Reply
#20
I was given this source by the one of the guys MiniMax sales guys in the US: Link. You have to become a member, but that's just a formality.

John
Reply

#21
Most locking rings are standard parts just like nuts and bolts.
In case yours are I suggest asking the local industrial supplier.
Part timer living on the western coast of Finland. Not a native speaker of English
Reply
MM 16 Parts Source


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.