06-14-2018, 10:44 PM
When you have a small work space, you have to get creative. That means keeping a lot of lumber outside. Today I pulled the lumber racks down and spaced them away from the wall the width of a 2x4 ( 3 1/2" ). This allows me to slide sheets of plywood in behind the other stuff. 'Cause nothing takes up a small work shop like a sheet of plywood.
Because I consolidated 2 piles of junk into one, my racks were going to have a lot of wasted space. Luckily, as I was cleaning I found 2 pieces of rebar on the ground. I just drilled a hole in each upright and hammered them in. Used up the wasted space, it was a quick fix, and they're strong.
Anyway, just a little quick and dirty job but it always feels good to get 'er done!
Paul M
Because I consolidated 2 piles of junk into one, my racks were going to have a lot of wasted space. Luckily, as I was cleaning I found 2 pieces of rebar on the ground. I just drilled a hole in each upright and hammered them in. Used up the wasted space, it was a quick fix, and they're strong.
Anyway, just a little quick and dirty job but it always feels good to get 'er done!
Paul M