#28
What is the best bit(?) to drill thru particle-board?
Reply

#29
A brand new brad point bit.

The support above and below are probably more important than the bit itself. High speed, slow entry. Maybe, if you're able, set the bit depth stop so that the brad point just pokes through, then stops. Flip the piece over and line up the bit with the tiny hole.

Maybe cover the holes(above and below) with tape, that way when you remove the tape and chips come off anyway, you can glue the those chips back in.

Maybe don't use particle board. Sorry, had to.
Reply
#30
If I could... I would choose the material not to be "strand-board"... Just learned the correct name.  I'm attempting to drill a large hole to feed wires from basement up-thru the strand-board.  

Suggestions?
Reply

#31
(04-11-2020, 01:42 PM)CCinPA Wrote: If I could... I would choose the material not to be "strand-board"... 
[quote pid='7846782' dateline='1586630533']
Carpenters call it OSB for oriented strand board.  If you are worried about it start with a small drill bit 3/16 maybe then follow with a hole saw or spade bit then go the the other side and finish the hole.  Or you can do like every carpenter electrician and plummer and just drill baby drill.  No one cares what the back side of OSB looks like.
[/quote]
A carpenter's house is never done.
Reply
#32
Holesaw. Nice and sharp. Stop before it goes through, then drill on the other side.
Steve

Mo.



I miss the days of using my dinghy with a girlfriend too. Zack Butler-4/18/24


 
The Revos apparently are designed to clamp railroad ties and pull together horrifically prepared joints
WaterlooMark 02/9/2020








Reply
#33
Depending on the depth of the hole, you may end up having to start with a small drill bit(the diameter of the pilot bit in your hole saw), go a little ways from both sides with the hole saw to get clean entries, then get the middle with a spade bit.
Reply
#34
What size hole? Depending on the size, there may be other options besides a holesaw.
I no longer build museums but don't want to change my name. My new job is a lot less stressful. Life is much better.

Garry
Reply
#35
Particle board and OSB are two totally different products. Particle boaed is mostly saw dust and glue while OSB is thin chips and glue. Osb is usually structural. Particle board is not, but is very hard. used to be used a lot for underlayment.
Reply
#36
How thick is the material you are attempting to drill through? What diameter hole?

Doug
Reply

#37
(04-11-2020, 10:04 PM)Tapper Wrote: How thick is the material you are attempting to drill through? What diameter hole?

Doug

Yep.. The partial-board(strand-board) is a 1" underlayment.  Then, 2" pine stud.
Reply
What is the best bit(?) to drill thru particle-board?


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.