Time to get caught up. Drawer #2 is completed...handled, and stashed away..
Handles needed reground...didn't care for the shape they came in..
So, a grinder and a cup of water..
Should do the trick. Drawer itself got planed...
Marks made to center the handle on the drawer front..
Pilot holes for the screws was by North Brothers #41...Checked drawer #1..
Thought I heard something rattling around....
Drawer #3 was then dovetailed, bottom was cut to fit...and that forest of clamps came back..
And I thought I was down for the day...
Decided I wanted a molding around the drawer openings, to give something for the doors to rest on..
nothing fancy, mind you. But to get the needed stock, I needed to rip a few 1 x 6s down....might as well mill the parts for the doors, too..
4 stiles, and 4 rails...grooved for the plexiglass panel, too.
Means I need to sketch up all the cuts I need to make...to make the two doors. After I get the last drawer done.
Sure to involve a bit of cussing...
Stay tuned...